Koz Ross on Nostr: So I had to interrupt my resin tuning thread because I, uhh, ran out of the resin I ...

So I had to interrupt my resin tuning thread because I, uhh, ran out of the resin I was tuning. Luckily I had some spare, in clear, and finally settled on a 3.4s exposure.

So, to celebrate, printing this absolutely huge fox. This thing's print height is almost 220mm, and the estimate is _under five hours_. I of course hollowed it, but even then, this is 150g of resin.

#Resin3DPrinting #3DPrinting

3D Printing (npub1d4n…dptf)